Brigade Vikings III: Metal, Wood, & Flesh

My preferred method of painting is to work from the innermost levels of the figure outward: thus, In paint flesh and hair and then work out through the various layers of clothing and equipment.

Except...

I always paint the metal armor of chain and plate first. It's a messy process of drybrushing that has a tendency to got little bits of metal around. Naturally, this includes the various sword, spear and other weapons. Here are a series of pictures showing chainmail and some helmets in progress.

Shade Coat

Mid-Level

Wash
Highlight

Following the armor, I paint the wood of any spears, axes or other hand weapons.

Then, it's time to do the flesh, hair, clothes, and lastly equipment. Here are the results before Clear coat and basing:

Brigade Games Vikings: Shields

First in the process is to prime with Black and then damp brush white. I neglected to photograph those stages; but here is a shot of the shields after I applied the metal shade to the bosses:

Next was to paint and stain the wood emphasizing the wood grain. Then, I painted the leather handles and the steel rim...which should be leather, but the commission dictates.

Finally, shield patterns were accessed from various fan sites for the show Viking. Here are the results:

Brigade Games Vikings II: Mould line correction

Sometimes after cleaning and priming one discovers mould lines...it's frustrating but definitely worth the time it takes to correct them. Take a deep breath and look before you start the scrape and file...

I found six figures that needed remediation.  Three had very faint lines which required another scrape with a knife. The fourth was a mystery how I had missed the lines. The fifth actually required some careful filing as the line ran from hair to forehead to neck. The sixth was an accident...it seems the Vikings had trousers with a seam down the side and I scraped the primer but not the seam before I realized my mistake.

Here's the process I followed: clean the figure up. Next brush paint on some black primer. Let the primer thoroughly dry.  Repairing the prime levels is a slow process as you need each level to fully dry. I tend to leave them perhaps an hour unless I use an oven.  When the primer is ready, dry brush on skeleton bone and let thoroughly dry. Finally, dry brush white on the figure and dry.

Brigade Games Vikings Painted awaiting basing...

Recently, I was commissioned by Brigade Games to paint some of their Viking figures. A total of seventeen figures were sent. Packs 12-19. I started them some time ago; but haven't posted until now.

These are the figures after I spray primed with Games Workshop Black, zenithal spray primed with Skeleton Bone by Army Painter; and damp brushed with Vallejo White. I neglected to take pictures at each stage...but here is a photograph of them after I glued on a mixed sand.

Looking over the photograph posted on Instagram, I did notice a mould line or two that escaped the preparation the first time.

The next step is to correct the mould lines and apply base coats.